Integrated School Communications

The CM-800 is a networked audio decoder that accepts streaming audio input (raw PCM) and delivers line level audio output.  The primary purpose of the CM-800 is to provide connectivity between the Calypso Conductor IP-based paging system and standard 70v amplifiers and speakers frequently used to bring audio messaging to school common and outdoor areas.  As such, the CM-800 converts 8KHz-sampled audio to line level audio output, suitable for use as an input to standard, 3rd party amplifiers.

In addition, the CM-800 provides serial, IR, GPI and GPO (relays) to support network-based 3rd party device control.  In addition, an optional 30W amplifier module for driving speakers directly turns the CM-800 into the CM-800S, capable of driving up to four 8ohm speakers, conveniently bringing IP paging to small common areas and shared office spaces. 

When not streaming audio the CM-800 mixes, samples and plays line level audio from two inputs at 48kHz.  A unique configuration feature of the CM-800 is the ability to detect audio at the inputs and automatically stream this audio over the network.  Accordingly the unit can be used to convert a standard analog paging system into an IP-based, streaming solution.

As with most Calypso products, CM-800 and CM-800S configuration and setup is conveniently done through any standard browser connected to the CM-800 directly or over a network.

  • Connect IP Paging to Standard 70v Amplifiers for School Common Areas (CM-800)
  • Bring Stream Audio to School Offices and other non-classrooms
  • Cost effective
  • PoE Compatible
  • Case dimensions: 3.84 x 2.5 x .913 (CM-800), 3.84 x 2.5 x 1.2 (CM-800S)
  • Ethernet jacks: RJ45 (1)
  • Audio Input plug: 3.5mm (tip, ring, sleeve)
  • Mic/Line Input plug: 3.5mm (tip, ring, sleeve)
  • Amplifier Line Out plug: 3.5mm (tip, ring, sleeve)
  • General purpose relay outputs (2): 4 position, 3.81 mm terminal block header
  • General purpose inputs (3): 4 position , 3.81mm terminal block header
  • IR output plug: 3.5mm
  • Amplifier Speaker Out connector (CM-800S): 4 position, 3.81mm terminal block